MEGAFORM XL
Ultimate Vacuum Forming Systems
MAXIMUM HEIGHT
With a Massive Z Height of 29.5 inches, the MEGAFORM XL can handle some of the industries most difficult designs and creations.
Never worry about design height limitations again!
The MEGAFORM XL also uses 8 massive 1 inch nuts and bolts to evenly tighten and apply the maximum amount of pressure possible to the entire outer edge of your plastic sheet to ensure that plastics can never escape once locked in.
MASSIVE FORMING AREA
HUGE 24X24 sheet loading area ensures that there is enough room for even the largest of designs.
Since the MEGAFORM XL accepts industry standard sheet sizes you never need to get a sheet custom cut again!
DUAL OUTLET PORTS
Use what you need!
Small jobs usually only require a normal vacuum, but for larger jobs that have deep draws and sharp angles don't worry! You can attach your vacuum pump here.
Vacuum opening is 48.5mm wide
Vacuum pump port is for 3/8 hoses.
The MEGAFORM XL requires 220V.
SAFETY AUTO OFF TIMER
Never worry about your system running for too long!
The MEGAFORM system comes with a built in timer relay!
Set the amount of time needed for the job and power will be automatically cut off without a second thought!
LIGHT WEIGHT PULLEY SYSTEM
Carbon fiber plates and stainless steel standoffs are used to created the lightest yet strongest frame possible.
Easily raise and lower your frame by pulling the carabiner hooks up or down!
Hook onto the pins below to lock into place!
MORE FEATURES
-
ULTRA GRIPTAPE ACTION
The MEGAFORM XL is the only vacuum former which effectively solves the problem of thicker plastics slipping out of frame when high downward pressure is applied. Never worry about slipouts ever again!
-
MAGNETIC SAFETY ON/OFF SWITCH MECHANISM
The MEGAFORM XL also includes a special safety magnetic ON/OFF switch. This switch gives you the ability to lock the ON button so that it cannot be pressed down and features a massive OFF lever allowing you to switch the sytem off with ease.
-
CARABINER HOOK
When raising your frame upward simply hook onto the pins like you see above to lock your plastic into place right in front of the heating element!